There are few conveniences in life that can compare to the simple, visceral pleasure that comes with having a hot shower. It’s more than just a way to get a refreshing clean and a head start on a new day. For many, it’s a transformative experience that elevates their mood while delivering a deeply felt sense of relaxation and satisfaction. This isn’t just hyperbole. Think about how great a hot shower feels before you head off to work in the morning or after a tough workout, and you will most definitely agree.
We couldn’t agree more ourselves at Harris Water Heaters because we value a good, long shower after a day of helping our customers with water heater repair in Pleasanton, CA. We’re also going to help you by providing a bit of information here that will make sure your heater is ready to deliver a comfortable cascade of warmth when you need it.
Before you need water heater repair in Pleasanton, CA, you can ensure that you get a warm shower daily by calling on an experienced company like ours for regular maintenance and cleaning. In this way, you can make certain your water heater works as it should. Additionally, if you need a new heater, get it installed correctly by trained technicians and you can look forward to enjoying warm showers again.
If your water heater breaks down, you can get an expert to do water heater repair in Pleasanton, CA, but a little preventive maintenance should keep it flowing reliably and extend its life for years. Before starting, make sure to turn off the power (for electric water heaters) or the gas supply (for gas heaters).
Do a Mini-Flush
Place a large bucket under the drain valve at the bottom of the water heater tank and turn the valve counterclockwise to release a couple of gallons of water into the bucket. It’s important to note that the water will be very hot, so take care not to burn yourself. Close the valve by turning it clockwise. If the valve will not open, contact a plumber for water heater repair.
Test the T&P Valve
To test the valve, place a bucket under the end of the discharge tube connected to the T&P valve. Lift the lever of the valve to open it manually. This releases hot water into the bucket. Warning — this water will be very hot. Let the water flow for a few seconds, then let go of the lever. Allow it to snap back, shutting off the water. If the T&P valve does not open and release water or if it leaks after the test, you will need water heater repair to replace the valve.
Dial Down the Temperature
On a gas water heater, turn the temperature dial on the heater’s gas valve to 120° F.
For an electric water heater, you may need to remove a small metal panel covering the thermostat.