Phone and speech bubble icon
Licensed and Insured #1026214

Posts made in April 2020

Do I Need a Tankless Water Heater in My Home?

A tankless water heater is a fantastic piece of equipment for creating a more energy-efficient home. Unlike standard units that need to heat and reheat water continuously, tankless water heaters in Pleasanton, CA, generate hot water on demand, with gas burners or electric coils. While it’s true that this type of heating requires more power, because a large amount of water does not have to be reheated over and over, tankless systems use less energy overall.

Here are some of the benefits of tankless water heaters:

Endless Hot Water – Though they may take a moment to heat up, once they do tankless water heaters can provide an endless stream of hot water. A tankless heater ensures that everyone has a hot shower, though there is a limit to how much hot water can be produced at once.

Longer Lifespan – A standard water heater will last roughly a decade, whereas tankless models last for twice as long. This adds to the cost savings you’ll receive by switching to a tankless model.

Lower Monthly Costs – While these systems are more expensive up front, they are also more efficient. Consumer Reports says that tankless water heaters are 22% more efficient, resulting in monthly savings.

Less Physical Space – Tankless water heaters are much smaller than storage models, easily mountable on walls either on the interior or exterior of homes. For smaller homes, the space savings is a huge benefit.

Taking Care of Your Water Heater

Water Heater Repair in Pleasanton, CAIf your water heater breaks down, you can get an expert to do water heater repair in Pleasanton, CA, but a little preventive maintenance should keep it flowing reliably and extend its life for years. Before starting, make sure to turn off the power (for electric water heaters) or the gas supply (for gas heaters).

Do a Mini-Flush

Place a large bucket under the drain valve at the bottom of the water heater tank and turn the valve counterclockwise to release a couple of gallons of water into the bucket. It’s important to note that the water will be very hot, so take care not to burn yourself. Close the valve by turning it clockwise. If the valve will not open, contact a plumber for water heater repair.

Test the T&P Valve

To test the valve, place a bucket under the end of the discharge tube connected to the T&P valve. Lift the lever of the valve to open it manually. This releases hot water into the bucket. Warning — this water will be very hot. Let the water flow for a few seconds, then let go of the lever. Allow it to snap back, shutting off the water. If the T&P valve does not open and release water or if it leaks after the test, you will need water heater repair to replace the valve.

Dial Down the Temperature

On a gas water heater, turn the temperature dial on the heater’s gas valve to 120° F.

For an electric water heater, you may need to remove a small metal panel covering the thermostat.